Step-by-Step Guide: Connecting GoodWe Inverter to Wi-Fi

Step-by-Step Guide: Connecting GoodWe Inverter to Wi-Fi

Step-by-Step Guide: Connecting GoodWe Inverter to Wi-Fi

  1. Download and Open PV Master

    • Install it from the App Store or Google Play Store.

    • Open the app and select “Local Mode.”

  2. Connect to the Inverter's Wi-Fi

    • On your phone, go to Wi-Fi settings.

    • Look for a network like: Solar-WiFi_XXXXXX or GoodWe-XXXXXX

    • Connect to it. (No password required in most cases.)

  3. Go Back to the PV Master App

    • It will auto-detect the inverter once connected.

    • Tap the inverter shown, and then click “Wi-Fi Settings.”

  4. Select Your Home Wi-Fi

    • The inverter will scan and show a list of available Wi-Fi networks.

    • Select your home Wi-Fi, then enter the password.

    • Confirm and wait for configuration (can take up to 2 minutes).

  5. Check Status

    • The app should say “Connected” once successful.

    • The green light on the inverter will also confirm internet connection.

Optional: SEMS Portal Setup (for monitoring)

After connecting to Wi-Fi, you can monitor your system via the GoodWe SEMS Portal:

    • Related Articles

    • Step-by-Step Guide: Connecting Victron Devices to Wi-Fi

      Step 1: Prepare Your Victron Device Ensure that your Venus GX or Cerbo GX is powered on and fully initialized. The device should have its display or LEDs active. Step 2: Access Wi-Fi Settings on Your Victron Device Option 1: Using the Display (for ...

    • Step by Step Guide: Connecting a Sungrow Inverter to Wifi

      Step 1: Download the iSolarCloud App Download the iSolarCloud app from the App Store (iPhone) or Google Play Store (Android). Step 2: Connect to the Inverter’s Wi-Fi On your phone, go to Wi-Fi settings. Look for a network that starts with "SG-" ...

    • Step by Step Guide: Connecting Fronius Inverter to Wifi

      Step 1: Activate the Inverter's Wi-Fi Access Point On the inverter's screen, press the Enter key (middle button). Navigate to: Setup > Wi-Fi Access Point > Enable The inverter will start broadcasting a network like: FRONIUS_240.xxxxxx ? Step 2: ...

    • Step By Step Guide: Connecting Solar Edge Inverter to Wifi

      Steps to Connect Your SolarEdge System to Wi-Fi: Turn on the Inverter: Ensure your SolarEdge inverter is powered on and functioning properly. Access the Inverter's Wi-Fi Settings: On the inverter, locate the "Communication" or "Wi-Fi" button (this ...

    • Step By Step Guide: Connecting SMA Inverter to Wifi

      ? Steps to Connect Your SMA Inverter to Wi-Fi: 1. Power On the Inverter Ensure your SMA inverter is powered on and the display (if applicable) is active. 2. Activate the Inverter’s Wi-Fi SMA inverters typically broadcast their own Wi-Fi network upon ...