How to Check the Battery Charging Rate (for VICTRON)

Go to Settings.

DVCC.

Maximum charge current. 

Increasing charge current allows the battery to absorb more power when solar production is high, reducing charging time. The highest allowable charge current will depend on the rating of the circuit breaker used in the system.

• Related Articles

• How to Fix Battery Cell Imbalance (BSL Battery)

  A battery cell imbalance may present through unusual SOC (State of Charge) behavior, red LED indicators, or system instability. If one battery in the stack is out of balance, it can cause inconsistent charging and affect overall performance. The goal ...

• Pylontech Battery – Basic Troubleshooting Guide

  This guide outlines the correct wiring, startup, and shutdown procedures for integrating Pylontech US5000 lithium batteries with a Victron inverter system via CAN-bus communication. It is compatible with Victron and Deye hybrid inverters. Quick Check ...

• BSL Battery – Basic Troubleshooting Guide

  Use this guide when setting up a BSL battery stack, or if your BSL batteries are connected but not working. Quick Check Verify CAN cable connection The cable from the inverter must be connected to the CAN port of the master battery. Inspect the RS485 ...

• Pylontech Battery - Basic Troubleshooting Guide (Batteries not discharging - Battery Monitor [512] Internal Failure Alarm)

  Once this is reported by the customer, we must first request for photos of the whole setup to check any wiring/connection anomalies. Then confirm the number of affected batteries by following the steps below 1: On the VRM portal, Go to Remote Console ...

• Understanding Battery Cell Imbalance

  Battery banks configured in parallel are common in solar energy storage systems. While parallel configurations increase amp-hour (Ah) capacity and enable higher energy reserves at a constant voltage, they also introduce a critical challenge: State of ...